Do it yourself
| ||||
|
BMW Serie 5 - Video tutorial
Model: BMW Serie 5
E39
- Years 1995-2003 Before proceeding with the disassembly of the door panel to access the windscreen mechanism, it is advisable to disconnect the battery located in the rear luggage compartment since the side airbag will have to be disconnected; once the battery has been disconnected, proceed with the disassembly of the door panel by first removing the caps on the armrest handle and then the molding in order to access the screws below; then unclip the panel along the edges and disconnect the lock cable and the loudspeaker socket to be able to remove it; remove the side airbag, detach the sound-absorbing lining, taking care not to tear it in order to reach the window lifting mechanism; then loosen the claws to remove the glass, unscrew the fixing pins of the mechanism and extract it from its seat; proceed in reverse to install the new one by moving the drive motor.
Posted on 24 August 2023 by ScegliAuto
Replacement of the window lifter mechanism of the BMW 5 Series.
BMW Serie 5 (1995-2003 / E39) Let's briefly see in this guide the instructions that will allow us to disassemble and replace the window lifter mechanism of the BMW 5 Series. First
Window lifter mechanism disassembly instructions
BMW Serie 5 (1995-2003 / E39) To be able to disassemble the window lifter mechanism complete with motor, the door panel must first be removed; even before disconnecting the socket
Check rear window lift anomaly
BMW Serie 5 (1995-2003 / E39) To be able to verify the malfunction of the rear door window, the panel must first be removed. Once the sound-absorbing coating has also been removed Other guides that may interest you
|
Fiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.085
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |