Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chrysler
    3. :
  3. Pt Cruiser
    4. : Ignition coil disassembly instructions

Chrysler Pt Cruiser - Video tutorial

Model: Chrysler Pt Cruiser MK 1 - Years 2000-2010
Part: Coil
Operation: Ignition coil disassembly instructions

The ignition coil is located just below the intake manifold and to be able to disassemble it you must first remove the manifold itself: start by disconnecting the sleeve that joins the throttle body to the engine air filter box; then disconnect the sockets, the cable glands and the vacuum tubes connected to the intake manifold and then unscrew the rear fixing pins and the front screws; therefore lift the intake manifold, protect the intake ports with a clean cloth to prevent debris from getting inside and complete the disassembly of the coil by first disconnecting the spark plug cables and then unscrewing the relative fixing pins.


Posted on 21 August 2023 by ScegliAuto



Front bumper removal instructions
Chrysler Pt Cruiser (2000-2010 / MK 1) The disassembly of the front bumper is extremely simple to carry out: it is a matter of unscrewing the relative fixing screws; start by opening the f
Throttle body removal instructions
Chrysler Pt Cruiser (2000-2010 / MK 1) If the engine struggles to keep idle or gaps appear during acceleration, it could be a malfunction of the throttle body and the solution to the probl
Front grill disassembly instructions
Chrysler Pt Cruiser (2000-2010 / MK 1) The front grille integrated in the front bumper is fixed to the bonnet bumper with two screws for each end and then wedged along the edges to the bum

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos