|
Do it yourself
| |||
| ||||
Installation of a 2DIN radio on a 2010 Citroen Berlingo.
Model: Citroen Berlingo
MK 1
- Years 1996-2013
Is it possible to install a 2DIN car stereo on a 2010 Citroen Berlingo? The answer is definitely yes, but it is necessary to make a small modification to the dashboard trim, to which a strip must be cut in order to fit the Android multimedia screen. We follow the slides that are proposed to us: in fact, after removing the trim, which is only pressed in, we will have to remove everything in the central part, with a saw and a lot of precision. In this way we will have space for a nice screen: obviously we will also have to remove the buttons and the part of the bodywork that was behind this part that we are eliminating. Here too, a saw and a lot of precision will be needed, in addition to some electronic knowledge that allows us to remove the connections without causing damage. We put the multimedia screen in its place, where we have also connected the GPS antenna, which we have brought out of the dashboard at the top; to prevent the dashboard we have cut from collapsing, the youtuber has rightly installed two sturdy metal brackets that support it on the sides. We put the modified trim back on and the operation is complete.
Posted on 22 November 2025 by ScegliAuto
Video tutorial
Related tutorials
Citroen Berlingo
(2018-2026 /
MK 3)
To replace the radio in a Citroën Berlingo, use a tool to pry off the upper part of the central dashboard panel, disconnecting the connectors as well…
Citroen Berlingo
(2008-2018 /
MK 2)
In the following guide dedicated to all of you who own a Citroen Berlingo Mk2, we will discover the steps you need to take to correctly and safely re…
Citroen Berlingo
(2008-2018 /
MK 2)
To reset the radio in the Citroën Berlingo, connect a diagnostic tool to the vehicle's OBD port: this port is located at the bottom of the steering c…
Other guides you may be interested in
|
How to Open a Stuck Boot on the Peugeot 407?
On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.443
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |