Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Ignition Coil

Model: Dodge Charger LX - Years 2006-2011
Part: Ignition coil

If you experience engine starting issues or if the engine runs unevenly once started, it is likely that combustion is not occurring in some cylinders due to a failure of the ignition coils: performing a diagnosis on the engine management ECU may reveal the fault code related to the misfire along with the cylinder number reference. To remove the coil, you must first remove the plastic cover under the windscreen, the wiper motor assembly, and the intake hose complete with throttle body, before removing the intake manifold located on top of the engine.

Updated on 18 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Rear Headlamp Bulb
Replacing the Rear Headlamp Bulb
Dodge Charger (2006-2011 / LX) Replacing the rear headlamp bulbs is straightforward, as disassembling the headlamp itself is also quite simple. Open the rear bonnet and locate the …
Replacing the Engine Air Filter
Replacing the Engine Air Filter
Dodge Charger (2006-2011 / LX) Replacing the engine air filter is a simple task that allows you to save money on mechanic fees if you do it yourself. This filter ensures that clean…
How to Replace the Wiper Blades on Your Car
How to Replace the Wiper Blades on Your Car
Dodge Charger (2006-2011 / LX) Replacing the wiper blades is one of those tasks you can do on your own car as a DIY project, allowing you to gain some personal satisfaction and sav…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos