Do it yourself
Frequently asked questions about cars and motorcycles

How to change the engine oil, oil filter, and air filter in a Fiat Ducato DIY

Model: Fiat Ducato X290 - Years 2014-2026
Part: Engine oil

On the Fiat Ducato, the engine maintenance operation involves draining the oil, replacing the oil filter, and the air filter. Place the Fiat Ducato on a flat surface, slightly warm up the engine, and then turn it off. Position a container under the oil pan, unscrew the drain plug, and let the oil flow out; replace the washer and screw it back in, tightening it to the specified torque.

Next, address the oil filter: if it is a spin-on type, unscrew it, lubricate the seal of the new one, and hand-tighten it until it is snug, plus a quarter to half a turn; if it is a cartridge type, open the filter housing, replace the cartridge and the O-ring, and then tighten it to the specified value.

For the air filter, open the airbox of the Fiat Ducato, remove the worn element, clean the housing, insert the new filter while respecting the flow direction, and close it, ensuring that the clips/Torx screws are properly seated.

Fill the engine through the valve cover opening with oil of the specified viscosity; pour gradually, wait a few seconds, and check the level. Start the engine for a few seconds to fill the system, turn it off, and recheck the level, topping up if necessary.

Finally, conduct a leak check and, if there is a warning light, proceed to reset the service interval from the Fiat Ducato's instrument panel.

Posted on 21 December 2025 by ScegliAuto

Video tutorial

Related tutorials

Fiat Ducato (2014-2026 / X290) Below is the procedure to perform routine maintenance by changing the engine oil and oil filter in the Fiat Ducato. First, drain the engine oil by un…
Fiat Ducato (2006-2014 / X250) To change the engine oil and filter in a Fiat Ducato, park the vehicle on a flat surface and safely lift it to access the underside of the engine. Po…
Fiat Ducato (1993-2016 / MK 2) In this video we see how to change the engine oil and filter on a Fiat Ducato X244: we start by going under the vehicle and removing the cap from the…

Other guides you may be interested in

How to Open the Bonnet of a Renault Megane if the Lever is Broken?

If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it.

Watch the video!


by ScegliAuto

More videos