Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : How do you replace the spark plugs on the Fiat 500?

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2022
Part: Spark plugs
Operation: How do you replace the spark plugs on the Fiat 500?

In order to replace the spark plugs on the Fiat 500, the hood must be opened, so that the screws that secure the plastic cover of the upper part of the engine compartment can be loosened, also removing the air filter. Once these components have been removed, it will be possible to unscrew the bolts that secure the coils, also disconnecting the connectors connected to them. By removing these coils, it will be possible to access the spark plugs below, which must be removed from inside their housing using a socket wrench. After removal it will be possible to insert the new ones by mounting all the components previously removed.


Posted on 5 May 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2012-2023 - How do you replace the spark plugs of the Fiat 500L? Read Answer
    • 500 2007-2022 - How much does it cost to replace the Fiat 500 spark plugs? Read Answer
    • 500 2007-2021 - Where are the spark plugs of the Fiat 500 1.3 MultiJet located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos