Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace Engine Oil and Filter on GMC Canyon Mk2

Model: GMC Canyon MK 2 - Years: 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022
Part: Engine oil

See other generations:
Video tutorial

This guide shows how to replace the engine oil in the GMC Canyon Mk2. First, open the hood and remove the cap from the oil filler neck. Once the vehicle is lifted, locate the drain plug on the oil pan and remove it with a 15 mm wrench to let the fluid drain into an appropriate container.

After this, close the drain plug and clean up any spills. Remove the oil filter using a 24 mm wrench with an extension; be careful of any lubricant leaks.

Replace the old cartridge and install the new element with the corresponding gasket. Fill the oil reservoir with the correct amount of oil, as specified in the vehicle's owner's manual.

Start the engine and let it run for a few minutes at idle to circulate the oil.


Updated on 22 May 2026 by ScegliAuto


Related tutorials

How to Replace the Dome Light Bulbs of the GMC Canyon
How to Replace the Dome Light Bulbs of the GMC Canyon
GMC Canyon (2015-2022 / MK 2) This guide provides instructions to remove and replace the bulbs of the interior dome light of the GMC Canyon. First, get in the vehicle and start re…
How to Replace the Headlight Bulb on a GMC Canyon
How to Replace the Headlight Bulb on a GMC Canyon
GMC Canyon (2015-2022 / MK 2) To replace the headlight bulb on a GMC Canyon, open the hood to access the components in the engine compartment. Locate the protective cover over the…
How to Change the Air Filter on a GMC Canyon
How to Change the Air Filter on a GMC Canyon
GMC Canyon (2015-2022 / MK 2) To replace the air filter on the GMC Canyon, open the hood and access the air filter box located on the left side of the engine block. Loosen the hos…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos