Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Santa Fe
    4. : How to replace a diesel filter on Hyundai Santa Fe

Hyundai Santa Fe - Video tutorial

Model: Hyundai Santa Fe MK 2 - Years 2006-2012
Part: Diesel filter
Operation: How to replace a diesel filter on Hyundai Santa Fe

How to replace the diesel filter on Hyundai Santa Fe? Let's see the replacement in this video: open the car door and pull up the engine compartment opening lever located at the bottom left of the dashboard, lift up the front hood and put it in safety. With a socket wrench we unscrew the locking pins placed on the container (disconnect the cables and the various tubes from the filter) where the diesel filter is located. We extract the diesel filter, remove it and replace it with a new one. Finally we reassemble the various pipes of the supply and the diesel sensor, tighten the locking pins. We close the front hood.


Posted on 22 October 2023 by ScegliAuto



Replacing the diesel filter on Hyundai Santa Fe
Hyundai Santa Fe (2006-2012 / MK 2) Let's see in this video tutorial how to replace the diesel filter on a Hyundai Santa Fe 2.2l 150 hp, model produced from 2007 to 2012. The filter is
How to replace the Hyundai Santa Fe diesel filter
Hyundai Santa Fe (2012-2018 / MK 3) The diesel filter is located in the engine compartment, immediately under the windscreen, near the passenger side shock absorber dome; start by disco
How to replace the air filter on Hyundai Santa Fe
Hyundai Santa Fe (2012-2018 / MK 3) To replace the air filter of the Hyundai Santa Fe we start by opening the engine hood, we release the tabs that hold the cover of the air filter box,

Other guides that may interest you

    Frequently Asked Questions

    • Santa Fe 2006-2012 - Where is the Hyundai Snata Fe diesel filter located? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos