Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I10
    4. : Replacing the water pump on Hyundai I10

Hyundai I10 - Video tutorial

Model: Hyundai I10 MK 2, IA - Years 2013-2020
Part: Pump
Operation: Replacing the water pump on Hyundai I10

Raise the hood and secure it. As shown in the video, the water pump is located next to the engine compartment, on the passenger side and behind the alternator belt pulley. Disconnect the battery for safety, then go underneath the car to remove the drain plug on the corner of the radiator. Once the circuit has been emptied and the liquid collected in a container, go back to the top of the hood and unscrew the four bolts of the pulley, then loosen the pulley and remove the alternator belt. Continue to follow the video until the pump is removed.


Posted on 16 February 2024 by ScegliAuto



How to change timing belt and water pump on Hyundai I10 1.1
Hyundai I10 (2007-2013 / MK 1, PA) In this guide we will see the instructions that will allow us to disassemble and replace the timing belt and the water pump of the Hyundai I10 1.1. F
Replacing the timing belt on Hyundai I10
Hyundai I10 (2007-2013 / MK 1, PA) Replacing the timing belt on Hyundai I10, let's see how it is changed. We raise the front hood of the car; we remove the soundproofing panel, the air
How to replace the fuel pump of the Hyundai I10 1.2
Hyundai I10 (2007-2013 / MK 1, PA) Let's briefly see the steps that will allow us to disassemble and replace the fuel pump of the Hyundai I10 1.2. First of all, we open the rear doors

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos