Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Elantra
    4. : Fuel pump relay position

Hyundai Elantra - Video tutorial

Model: Hyundai Elantra MK 2, J2 - Years 1995-2000
Part: Pump
Operation: Fuel pump relay position

If it happens that the engine does not start even if it turns regularly with the starter motor, it is likely that no fuel arrives due to a malfunction of the pump (which is immersed in the tank, under the rear seat seat) or of the fuel system. power supply of the same (fuse or relay); It is therefore advisable to check if current is reaching the pump with a pilot light or with a voltmeter: if the current does not arrive and the fuse is intact then the cause of the fault is to be attributed to the relay; this is located under the dashboard on the driver's side, in the lower left corner, behind the harness and is characterized by a blue colored side.


Posted on 25 August 2023 by ScegliAuto



How to disassemble the fuel pump of the Hyundai Elantra
Hyundai Elantra (2006-2010 / HD, MK 4) How do I disassemble the fuel pump of the Hyundai Elantra? To begin we disconnect the battery cables, then, we remove the rear seat of the car. With
Replacing the fuel filter on Hyundai Elantra
Hyundai Elantra (2006-2010 / HD, MK 4) Removing the fuel filter on Hyundai Elantra? We disassemble the fuel filter together with the pump. We disassemble the rear seats, remove the metal c
Where is the fuel pump located in the Hyundai Elantra?
Hyundai Elantra (2006-2010 / HD, MK 4) In this video, we can see where the fuel pump is located in the Hyundai Elantra and how to proceed in case we need to replace it. As shown, the pump

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos