Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jaguar
    3. :
  3. Xe
    4. : Instructions for disassembling the fuse holder keyboard

Jaguar Xe - Video tutorial

Model: Jaguar Xe MK 1 - Years 2015-2023
Part: Checks and maintenance
Operation: Instructions for disassembling the fuse holder keyboard

A fuse and relay holder keyboard is located in the engine compartment, near the battery housing: before proceeding with the keyboard disassembly, it is recommended to disconnect the battery and remove it from its housing together with its case to have more room for maneuver; then unscrew the fixing pin of the keyboard so as to move it away from its seat and disconnect the sockets below; to complete the disassembly it is finally necessary to remove the lateral plastic cover under which the eyelets of the power cables are connected, including the ground one: then unscrew the fixing nuts of the eyelets and remove the cables.


Posted on 28 August 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Xe 2015-2023 - What problems could the Jaguar Xe present? Read Answer
    • Xe 2015-2023 - Every how many km should the Jaguar Xe be serviced? Read Answer
    • Xe 2015-2023 - What problems does the Jaguar XE have? Read Answer
    • Xe 2015-2023 - What are the problems of the Jaguar XE? Read Answer
    • Xe 2015-2023 - How many km do you need to service the Jaguar XE? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos