Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of LED Projector Headlights

Model: Jeep Wrangler MK 3, JK - Years 2007-2018
Part: Accessory kit

Installing LED projector headlights will give the front of the vehicle a very modern and appealing look while ensuring greater brightness; to install the new headlights, it is necessary to remove the front grille: first, remove the pin and then the entire pressure clip, repeating the operation for all clips along the bonnet closure line; then disconnect the fog light power connectors and remove the grille; unscrew the fixing screws of the frame around the headlight and remove the headlight itself by disconnecting the corresponding power connector; then connect the adapter cable to the original wiring connector along with the control unit, connecting the other end of the cable to the new headlight; tidy up the new wiring, fit the new headlight in its place, and secure it with the corresponding frame; then proceed in reverse for reassembly.

Updated on 15 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Front Headlights on a Jeep Wrangler
Replacing Front Headlights on a Jeep Wrangler
Jeep Wrangler (2007-2018 / MK 3, JK) Start by opening the bonnet and locating the screws that support the central grille, each covered by a recognisable plastic cap, and remove them. Now…
How to Replace the Headlights on a Jeep Wrangler
How to Replace the Headlights on a Jeep Wrangler
Jeep Wrangler (2007-2018 / MK 3, JK) Today, in this brief and simple guide, you will find step-by-step instructions for removing and replacing the front headlights on a Jeep Wrangler. Fi…
Replacing Front Headlights and Fog Lights
Replacing Front Headlights and Fog Lights
Jeep Wrangler (1997-2007 / MK 2, TJ) Lift the bonnet and remove the clips securing the front grille to the car body. Disconnect the connector for the dipped beam headlights. Now, you can…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos