Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Wrangler
    4. : Accessory Kit

Jeep Wrangler - Accessory Kit

Jeep Wrangler (2007-2018 / JK, MK 3)
Replacement of a rubber closure kit
In this guide we will replace some rubber parts, more precisely the closing kit which, being very worn, is no longer efficient. Let's start by disassembling …read all…
Posted on 20 September 2023 by ScegliAuto
Jeep Wrangler (2007-2018 / JK, MK 3)
Installation of LED lenticular lights
Installing LED lenticular headlights will give the front of the car a very modern and captivating look as well as guaranteeing greater brightness; to be able …read all…
Posted on 16 August 2023 by ScegliAuto
Jeep Wrangler (1997-2007 / TJ, MK 2)
Tank protection plate installation
In order to install a tank protection plate, the tank itself must be dismantled. Therefore, place a jack under the tank to facilitate its extraction from …read all…
Posted on 2 July 2023 by ScegliAuto
Airbags (1) Alternator (1) Loudspeaker (3) Air conditioning (1) Car stereo (8) Battery (11) Grille (1) Gearbox (3) Spark plugs (1) Soft top (1) Bodywork (2) Glove box (1) Key (17) Timing belt (3) V-belt (1) -board computer (11) Checks and maintenance (26) Throttle body (1) Dashboard (1) Bearing (2) Brake discs (2) Headlight (9) Tail light (4) Air filter (8) Cabin air filter (8) Diesel filter (1) Oil filter (4) Hand brake (1) Grille (3) Accessory Kit (3) Light bulb (3) Side turn signal light bulb (4) Headlight bulb (4) Rear light bulb (2) Interior lights ceiling light bulb (1) Antifreeze liquid (2) Dashboard light (1) License plate light (2) Third brake light (2) Handle (1) Engine (1) Starter motor (3) Gear oil (1) Brake oil (2) Engine oil (9) Power steering oil (1) Door panel (3) Front bumper (2) Rear bumper (2) Brake pads (6) Tires (2) Gear Shift Knob (6) Door (8) Instrument cluster (12) Radiator (1) Passenger compartment heating radiator (1) Wheel (3) Fuse box (9) Seat (5) Drive shaft (2) Crankshaft RPM sensor (1) Outside rearview mirror (6) Drums and shoes (1) Windscreen wipers (5) Thermostat (3) Transmission (3) EGR valve (1) Interior blower (1) Steering wheel (3)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos