Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Land Rover
  4. :
  5. Discovery
  6. : Differential lock lever installation

Land Rover Discovery - Video tutorial

Model: Land Rover Discovery L318, Discovery 2, MK 2 - Years 1998-2004
Part: Accessory Kit
Operation: Differential lock lever installation

Especially in four-wheel drive cars, having the ability to lock the differential is very useful in situations where the terrain puts a strain on the car. This device is not fitted as standard on all cars, therefore, where it is not present, a special kit must be fitted. Once the device has been installed on the differential, it is necessary to replace the stock dummy lever with the real command. The installation of the control lever involves the complete disassembly of the central tunnel then starting to remove the dummy lever and the gear knob, then using a plastic tool to avoid damaging the body, pry at the base of the tunnel around the rear ashtray to unclip the plastic clips and remove it in order to access the tunnel sealing screws. Remove the storage compartment of the tunnel and remove the screws on the bottom to lift the whole tunnel in order to recover the various electrical wiring prepared by the house for these accessories.


Posted on 18 July 2023 by ScegliAuto



How to replace the rear differential of the Land Rover Discovery
Land Rover Discovery (1998-2004 / L318, Discovery 2, MK 2) Today's guide will show us the main instructions on how to disassemble and replace the rear differential of the Land Rover Discovery. First, we lift
How the Land Rover Discovery gearbox works
Land Rover Discovery (1998-2004 / L318, Discovery 2, MK 2) In today's video we see how the gearbox of the Land Rover Discovery works. Specifically the small front lever. If we take it forward we activate the
How do you replace the driveshaft of a Land Rover Discovery?
Land Rover Discovery (1998-2004 / L318, Discovery 2, MK 2) In order to replace the transmission shaft of the Land Rover Discovery, you need to lift the car using a jack or a bridge so that you can access the

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos