Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Bumper on the Maruti Vitara Brezza

Model: Maruti Vitara Brezza MK 1 - Years 2016-2023
Part: Front bumper

This guide provides instructions to remove and replace the front bumper on the Maruti Vitara Brezza. First, open the hood and start unscrewing the mounting screws located at the top and bottom of the front bumper; then unscrew the additional screws located on both sides of the wheel wells, as shown in the video. Next, unscrew the screws of the front fog lights and remove the small grilles; then completely remove the front bumper, following the reverse procedure for reassembly!

Updated on 23 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Bumper on a Maruti Vitara Brezza
Maruti Vitara Brezza (2016-2023 / MK 1) If you need to replace the front bumper on your vehicle, you can check out the tutorial video and read the instructions below. First, open the hood, …
How to Replace the Fuel Filter in a Maruti Vitara Brezza?
How to Replace the Fuel Filter in a Maruti Vitara Brezza?
Maruti Vitara Brezza (2016-2023 / MK 1) To replace the fuel filter in a Maruti Vitara Brezza, open the hood to access the engine compartment directly under the windshield. In the center are…
How to Replace the Tail Light Bulb in a Maruti Vitara Brezza?
How to Replace the Tail Light Bulb in a Maruti Vitara Brezza?
Maruti Vitara Brezza (2016-2023 / MK 1) To replace the tail light bulb in a Maruti Vitara Brezza, open the rear hatch to access the screws next to the light. Once these screws are loosened …

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos