Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Thermostat Valve Replacement

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Thermostat

A malfunctioning thermostat valve can severely damage the engine as it controls the opening and closing of the cooling circuit (the valve can jam due to rust formation).
The replacement operation must be carried out with the engine cold, as water will leak from the system during disassembly. The valve is located at the bottom left of the engine (when viewed from the front) and is housed within a metal fitting to which the hoses are connected. Before installing the new one, carefully clean the seat and apply gasket sealant. Finally, restore the coolant level and replace it if necessary.

Updated on 7 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Thermostat on a Mazda CX-7 2.3
How to Replace the Thermostat on a Mazda CX-7 2.3
Mazda Cx 7 (2006-2012 / MK 1) Briefly, we will go through the main instructions for removing and replacing the engine coolant thermostat on a Mazda CX-7 2.3. First, open the bonne…
Replacing the Car Radiator
Replacing the Car Radiator
Mazda Cx 7 (2006-2012 / MK 1) The radiator is one of the most wear-prone parts of the car, being a very fragile component. This guide shows how to proceed with its replacement. A …
How to Replace Antifreeze
How to Replace Antifreeze
Mazda Cx 7 (2006-2012 / MK 1) Replacing the coolant is necessary and should be done regularly. It is especially important in winter when temperatures drop. First, disconnect the u…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos