Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. 6
    4. : Disassembly and replacement of Mazda 6 MK2 headlights

Mazda 6 - Video tutorial

Model: Mazda 6 GH, MK 2 - Years 2008-2012
Part: Headlight
Operation: Disassembly and replacement of Mazda 6 MK2 headlights

In this video tutorial we will see how to remove and replace the headlights of the Mazda 6 second series, following these simple and quick steps. First of all we open the bonnet and start by removing the clips that we find on the upper bulkhead of the front bumper; after which we unscrew the screws that we find on both sides of the wheel arches, as shown in the video. At this point we unclip the bumper on the sides, until it is completely removed; we finish removing the fixing screws of the headlights, disconnecting the electrical connector of the bulb to remove and replace it!


Posted on 21 August 2022 by ScegliAuto

This video is currently unavailable

    Frequently Asked Questions

    • Mazda 6 2008-2012 - How much does the Mazda 6 headlight cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos