Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Dismantle and Reassemble the Washer Fluid Pump

Model: Mazda 3 BK, MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Pump

See other generations:
Video tutorial

In the next video, a skilled guide will show how to access the washer fluid pump to dismantle and reinstall it. First, lift the lever located under the steering wheel to open the bonnet. Next, proceed to remove the front bumper (raise the car on a ramp, unscrew all the screws, remove the black panel underneath the car, and disconnect all connectors and sensors).

Then, extract the light unit (you will need to unscrew all its screws and bolts and disconnect all cables). At this point, underneath it is the pump, which you will drain and disconnect its cables.

Finally, dismantle it by unscrewing the bolts that hold it to the car. To reinstall it, perform all the previously mentioned operations in reverse, but first, ensure to replace the gasket.


Updated on 24 February 2026 by ScegliAuto


Related tutorials

How to Replace the Windscreen Washer Reservoir in the Mazda 3?
How to Replace the Windscreen Washer Reservoir in the Mazda 3?
Mazda 3 (2009-2013 / BL, MK 2) In this tutorial, you will learn how to replace the windscreen washer reservoir in the Mazda 3, a very simple task. Temporarily disconnect the upper …
Engine Coolant Replacement
Engine Coolant Replacement
Mazda 3 (2003-2009 / BK, MK 1) Lift the vehicle and secure it. Before proceeding, open the radiator cap. Remove the plastic cap located under the radiator using the special tool, t…
Power Steering Fluid Replacement
Power Steering Fluid Replacement
Mazda 3 (2003-2009 / BK, MK 1) Regular maintenance on your car will significantly extend its life. In this tutorial, you will see where to work to carry out these tasks. Open and l…

Other guides you may be interested in

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos