Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Coolant Replacement

Model: Mazda 3 BK, MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Antifreeze coolant

See other generations:
Video tutorial

Lift the vehicle and secure it. Before proceeding, open the radiator cap. Remove the plastic cap located under the radiator using the special tool, then place a container under the vehicle to collect the used coolant. Allow all the fluid to drain completely.

Close the lower cap and fill the radiator with new coolant to the level indicated on the expansion tank. Start the engine and run it until the thermostat valve opens.

When the engine is cold, top up the fluid if necessary. Antifreeze is a chemical product and must not be disposed of in the environment; take it to appropriate collection and disposal centres.


Updated on 7 February 2026 by ScegliAuto


Related tutorials

Coolant Temperature Sensor Replacement
Coolant Temperature Sensor Replacement
Mazda 3 (2003-2009 / BK, MK 1) It is advisable to perform this maintenance with the engine cold to avoid unpleasant burns; the coolant temperature sensor is located at the rear rig…
How to Check the Coolant Level
How to Check the Coolant Level
Mazda 3 (2003-2009 / BK, MK 1) Checking the coolant level is an important task. It can be done easily, even for those who are not familiar with automotive work. You do not need any…
Power Steering Fluid Replacement
Power Steering Fluid Replacement
Mazda 3 (2003-2009 / BK, MK 1) Regular maintenance on your car will significantly extend its life. In this tutorial, you will see where to work to carry out these tasks. Open and l…

Other guides you may be interested in

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos