Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 207
    4. : Where is the EGR valve located in the Peugeot 207?

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: EGR valve
Operation: Where is the EGR valve located in the Peugeot 207?

In this video we can see where the EGR valve is located in the Peugeot 207 and how to proceed in case we need to replace it. As shown, it is located in the center rear of the vehicle, just in front of the windshield. To access it and subsequently be able to disassemble it, first of all disconnect the intake manifold pipe, then remove the engine cover and unscrew the airbox fixing bolts. Once this is done, we continue by disassembling both the fuel filter and the lower half of the air filter and proceed to disassemble the valve.


Posted on 25 November 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 207 2006-2015 - Where is the EGR valve located in the Peugeot 207 1.6 HDi? Read Answer
    • 207 2006-2015 - How much does the EGR valve of the Peugeot 207 HDi 90 HP cost? Read Answer
    • 207 2006-2015 - Where is the EGR valve located in the Peugeot 207 1.6 HDI? Read Answer
    • 207 2006-2015 - Where is the EGR valve located in a 2006 Peugeot 207 HDi 1.6? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos