Do it yourself
Frequently asked questions about cars and motorcycles

Intermediate Shaft Bearing Replacement

Model: Porsche 911 996 - Years 1997-2005
Part: Transmission

It is recommended to perform this repair only if you have good mechanical knowledge and the proper tools!
The first step is to remove the transmission from the vehicle to place it on a workbench where you can replace the intermediate shaft bearing, but first, phase the engine by rotating the crankshaft pulley until you insert the pin into the designated hole and apply the appropriate template on the camshaft.
Then, unscrew the transmission oil drain plug, the nut at the center of the intermediate shaft bearing, and the three fastening pins of the flange, and remove the flange using the appropriate puller.
Using pliers, detach the retaining ring of the bearing and apply the specific puller to remove the bearing from its seat.
Then, clean the bearing seat thoroughly and install the new one, centering it with the appropriate tool; reinsert the retaining ring ensuring it fits perfectly into the groove, and finally reapply the flange (tightening the fastening pins with a torque wrench to 7 lb-ft) and the center nut (to 9 lb-ft).
At this point, you can reassemble the transmission, tightening the fastening pins to 59 lb-ft.

Updated on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Porsche 911 (1997-2005 / 996) Only perform this repair if you have the proper equipment and good mechanical knowledge, as it is necessary to disassemble the transmission, and any …
Porsche 911 (1997-2005 / 996) The intermediate shaft bearing can be found online for a price ranging from $30 to $50. If you plan to purchase the entire kit related to the shaft (…
Porsche 911 (1997-2005 / 996) Only perform this repair if you have good mechanical knowledge and the proper tools. The first step is to remove the transmission and place it on a w…

Other guides you may be interested in

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos