Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Scenic
    4. : Replacement of the air filter of the Renault Scenic IV.

Renault Scenic - Video tutorial

Model: Renault Scenic MK IV, MK 4, Scenic 4, Scenic IV - Years 2016-2022
Part: Air filter
Operation: Replacement of the air filter of the Renault Scenic IV.

In this video, we see how to proceed to replace the air filter of the Renault Scenic IV. We open the hood of the engine compartment, unscrew the supports of the brake fluid reservoir and the oil cap, detach the rubber gasket, unscrew the three screws that fix the grille under the windshield, position the windshield wiper blades vertically and remove the grille, unscrew the four screws that hold it and remove the transverse partition. We can now remove the cover of the filter box and the old filtering element will come out with it, replace it with a new one, make sure the box is clean and put the filter back in its place by locking the cover. We reassemble the parts by reversing the operations.


Posted on 12 February 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Scenic 2009-2015 - Where is the Renault Scenic 3 engine air filter located? Read Answer
    • Scenic 2003-2009 - Where is the Renault Scenic II engine air filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos