Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. BMW
  4. :
  5. Serie 7
  6. : Bodywork

BMW Serie 7 - Bodywork

BMW Serie 7 (2001-2008 / E65, E66, E68, MK 4, E67)
Manual closing sunroof

In the event that the sunroof remains open and perhaps it happens that the battery is discharged or for some reason the electrical system for closing does not …read all…
Posted on 12 September 2023 by ScegliAuto
BMW Serie 7 (1994-2001 / E38, MK 3)
Instruction for disassembling the under engine protection

Below the engine compartment there is a plastic protection that protects the engine from splashes while driving on wet roads but also has a function of …read all…
Posted on 24 August 2023 by ScegliAuto
BMW Serie 7 (2001-2008 / E65, E66, E68, MK 4, E67)
Bonnet support pistons installation

The pistons which support the bonnet and which at the same time also support it during the closing phase, are actually gas springs which tend to discharge over …read all…
Posted on 12 August 2023 by ScegliAuto
BMW Serie 7 (1986-1994 / MK 2, MK 3, E38, E32)
Front mudguard disassembly instructions

In order to remove the front fender it is first of all necessary to remove the front hood (the hood support hinge bracket is located on the edge of the fender) …read all…
Posted on 12 August 2023 by ScegliAuto

Airbags (6) Loudspeaker (2) Air conditioning (1) Car stereo (5) Battery (5) Air Vents (1) Bushings (2) Arm (4) Spark plugs (1) Bodywork (4) Control unit (2) Key (4) Timing belt (1) V-belt (1) Air conditioning controls (1) -board computer (6) Checks and maintenance (10) Dashboard (9) Brake discs (2) Headlight (3) Cabin air filter (4) Oil filter (1) Clutch (1) Grille (2) Accessory Kit (4) Light bulb (1) Side turn signal light bulb (1) Antifreeze liquid (1) Handle (4) Muffler (1) Engine (4) Window motor (1) Starter motor (1) Engine oil (1) Door panel (3) Front bumper (3) Rear bumper (2) Brake pads (1) Tires (1) Pump (1) Fuel pump (1) Door (1) Push button (1) Instrument cluster (2) Radiator (1) Fuse box (9) Seat (2) Parking sensors (1) Brake system (1) Lambda sensor (1) Outside rearview mirror (1) Manufacturer's coat of arms (1) Drums and shoes (1) Transmission (1) Central tunnel (2) Valve (2) Interior blower (2)

How to open the bonnet of the Volkswagen Polo

Let's see in this short and simple guide the instructions that will allow us to open the bonnet of the Volkswagen Polo. First of all we open the front door, on the driver's side, and start pulling the opening lever of the engine hood, in order to open the lock; then let's move to the front of the vehicle and unhook the tab that we find on the central part, above the manufacturer's emblem, as shown in the video. At this point we block the bonnet with the lateral rod; then we accompany the bonnet down to close it again!

Watch the video!


by ScegliAuto

More videos