Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Bumper of the Buick Enclave Mk1

Model: Buick Enclave MK 1 - Years: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Front bumper

See other generations:
Video tutorial

This guide shows how to remove the front bumper of the Buick Enclave Mk1. The first step is to remove the plastic cover of the engine compartment by detaching the plastic clips. Using a Torx T20 screwdriver, remove the screws on the top of the radiator grille.

Remove the two 10 mm bolts at the bottom of the bumper. Remove the two Torx T20 screws securing the wheel well at both ends.

Remove the screws securing the wheel well from the tire compartment. Remove the side bolt of the bumper and detach the trim insert.

Remove the 7 mm bolt and detach the end of the bumper. Disconnect the fog light connector and perform the same steps on the other end of the bumper.

At this point, firmly grasp the bumper and pull it out of its position. Reinstallation is done by reversing the steps taken so far.


Updated on 31 July 2026 by ScegliAuto


Related tutorials

Replacing the Front Headlight Bulb in the Buick Enclave
Replacing the Front Headlight Bulb in the Buick Enclave
Buick Enclave (2008-2017 / MK 1) Here are the instructions to remove and replace the front headlight bulb in the Buick Enclave. First, lift the vehicle and start removing all the pla…
How to Replace the Headlight Bulb on a Buick Enclave?
Buick Enclave (2008-2017 / MK 1) To replace the headlight bulb on a Buick Enclave, lift the vehicle so that the front wheel corresponding to the bulb to be removed is off the ground.…
How to Replace the Front Brake Pads on a Buick Enclave?
How to Replace the Front Brake Pads on a Buick Enclave?
Buick Enclave (2008-2017 / MK 1) To replace the front brake pads on a Buick Enclave, lift the vehicle so that the wheel corresponding to the pads being replaced is off the ground. On…

Other guides you may be interested in

How to Open the Fuel Filler Flap in the Hyundai i30?

In this tutorial, you will learn how to open the fuel filler flap in the Hyundai i30, a very simple operation that follows the typical procedure of most vehicles. First, unlock the locks using the designated button on the remote, then open the driver's door, locate the release lever on the left side of the seat, and operate it. Next, move to the fuel filler flap, open it completely, unscrew the cap, and refuel as needed. To close the flap, simply press it gently.

Watch the video!


by ScegliAuto

More videos