Do it yourself
| ||||
|
Fiat Panda - Video tutorial
Model: Fiat Panda
141, MK 1
- Years 1980-2003 In this video tutorial we will see how to remove and replace the clutch plates on the Fiat Panda 900 first series, following the instructions below. First we lift the car and start by removing the left front wheel; after which we drain the engine oil by unscrewing the vent bolt. At this point we are going to disassemble the front axle shaft, unscrewing the fixing screws of the arm to disconnect it from the braking system, as shown in the video; once the drive shaft has been removed we can unscrew the clutch cable, and then remove the gearbox support. Now we lift the gearbox with a jack and remove the starter motor; we just have to remove the gearbox and replace the clutch!
Posted on 21 February 2024 by ScegliAuto
Other guides that may interest you
|
Frequently Asked QuestionsHow to replace the AdBlue tank on Peugeot 3008In order to replace the AdBlue tank on the car it is necessary to know that it is located above the diesel tank and therefore under the rear trunk floor and to access it it is necessary: first of all lift the car on the deck, then remove the lower metal protective casing of the tank and under it we will find the diesel tank. Then proceed to disassemble the tank with the help of a forklift to support it. Once the diesel tank has been freed and lowered, above it we will find the small AdBlue tank. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.052
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |