Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : Lambda sensor

Ford Focus - Lambda sensor

Ford Focus (2011-2018 / MK 3)
Replacement of the lambda sensor of the Ford Focus.
Today's steps will show us the procedure for disassembling and replacing the lambda sensor of the Ford Focus, following the instructions below. First, we lift …read all…
Posted on 29 December 2023 by ScegliAuto
Ford Focus (2011-2018 / MK 3)
How do you replace the lambda sensor on the Ford Focus?
In order to replace the lambda probe on the Ford Focus, you need to open the bonnet, so that you can access the components located inside the engine …read all…
Posted on 19 April 2023 by ScegliAuto
Ford Focus (1998-2004 / MK 1)
Lambda replacement on Ford Focus
Let's see the replacement of the Lambda probe of a Focus. We raise the front hood of the engine, then we block the same. Remove the engine cover plastic panel, …read all…
Posted on 25 March 2024 by ScegliAuto
Ford Focus (2011-2018 / MK 3)
Ford Focus MK3 lambda probe replacement
In this video tutorial we will see how to remove and replace the lambda sensor sensor on a third series Ford Focus. We open and lift the bonnet and first of …read all…
Posted on 24 March 2024 by ScegliAuto
Ford Focus (2011-2018 / MK 3)
Replacing the lambda probe on the Ford Focus MK3 1.0 Ecoboost
In today's video tutorial we will see how to remove and replace the oxygen sensor or lambda probe on the Ford Focus third series, with the 1.0 Ecoboost engine. …read all…
Posted on 26 February 2024 by ScegliAuto
Cigarette Lighter (2) Airbags (5) Alternator (21) Loudspeaker (6) Shock absorbers (6) Antenna (9) Air conditioning (8) Car stereo (61) Anti roll bar (1) Roof Rack Bars (1) Battery (28) Coil (2) Air Vents (5) Bushings (2) Arm (1) Grille (1) Gearbox (2) Spark plugs (15) Glow plugs (3) Bodywork (8) Glove box (1) Control unit (8) Key (43) Locking the trunk (2) Timing belt (30) V-belt (5) Air conditioning (3) Air conditioning controls (4) -board computer (27) Checks and maintenance (146) Oil pan (1) Throttle body (1) Dashboard (15) Gearshift gaiter (1) Bearing (7) Brake discs (8) Rear bench seat (1) Side indicator light (2) Headlight (31) Tail light (11) Fog lights (8) Air filter (23) Cabin air filter (24) Petrol filter (10) Diesel filter (28) Oil filter (8) Hand brake (10) Clutch (7) Grille (6) Injectors (8) Window lift switch (2) Reverse gear switch (1) Accessory Kit (12) Light bulb (22) Side turn signal light bulb (9) Headlight bulb (37) Rear light bulb (26) Interior lights ceiling light bulb (12) Antifreeze liquid (3) Dashboard light (3) License plate light (4) Third brake light (3) Handle (18) Mask (1) Engine (17) Window motor (6) Starter motor (13) Engine oil (15) Power steering oil (2) Door panel (36) Windshield (1) Front bumper (17) Rear bumper (13) Brake pads (20) Hydraulic pistons (3) Tires (7) Gear Shift Knob (14) Pump (11) Fuel pump (30) Door (7) Push button (4) Window lift button (4) Instrument cluster (42) Radiator (9) Passenger compartment heating radiator (7) (1) Wheel (5) Fuse box (75) Seat (24) Drive shaft (2) Crankshaft RPM sensor (3) Coolant temperature sensor (1) Parking sensors (1) Lock (12) Lambda sensor (5) Suspensions (3) Outside rearview mirror (42) Interior rearview mirror (4) Engine mount (9) Drums and shoes (6) Windscreen wipers (19) Thermostat (10) Engine head (3) Transmission (1) Central tunnel (2) Turbine (7) Valve (3) EGR valve (5) Interior blower (18) Side window (6) Steering wheel (7)

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos