Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Ford
  4. :
  5. Focus
  6. : Bodywork

Ford Focus - Bodywork

Ford Focus (2011-2018 / MK 3)
Hood replacement on Ford Focus Mk3

Raise the hood and put on the support batten. On the right side of the vehicle, the hood has two internal clips that you need to remove with a small flat …read all…
Posted on 12 January 2024 by ScegliAuto
Ford Focus (2011-2018 / MK 3)
How to remove the spoiler from the car

Usually, the spoiler was fixed with putty or silicone by the body shop. The guide shows you how to remove it without damaging the paint or cracking everything. …read all…
Posted on 15 September 2023 by ScegliAuto
Ford Focus (1998-2004 / MK 1)
Removing the fuel tank filler pipe

The pipe that connects the tank cap to the tank itself passes from behind the wheel arch and over time can deteriorate due to corrosion; to be able to replace …read all…
Posted on 25 August 2023 by ScegliAuto
Ford Focus (2004-2011 / MK 2, Focus2)
Underbody heat shield fixing

A heat shield is positioned below the floor of the car, in correspondence with the passage of the exhaust pipe: it is a sheet of material resistant to high …read all…
Posted on 23 August 2023 by ScegliAuto
Ford Focus (1998-2004 / MK 1)
Removing the hood of the car

Removing the hood without adequate support could be a dangerous operation, as it could fall and you could be injured. Hence, one must always pay close …read all…
Posted on 21 August 2023 by ScegliAuto
Ford Focus (1998-2004 / MK 1)
Rear hood disassembly instructions

In order to remove the luggage compartment door, it is essential to disconnect all the sockets from the various devices to free and remove the wiring: start by …read all…
Posted on 18 August 2023 by ScegliAuto
Ford Focus (1998-2004 / MK 1)
Fender Replacement Guide

The mudguard is an important part of the car because it protects it from dust, stones, mud, etc. It is usually better to replace it than to have it repaired, …read all…
Posted on 11 August 2023 by ScegliAuto
Ford Focus (1998-2004 / MK 1)
How to remove a front fender

This tutorial explains how to remove the front fender of a Ford Focus. First you will need to jack up the car and remove the wheel from the fender you want to …read all…
Posted on 14 July 2023 by ScegliAuto

Cigarette Lighter (2) Airbags (5) Alternator (21) Loudspeaker (6) Shock absorbers (6) Antenna (9) Air conditioning (8) Car stereo (61) Anti roll bar (1) Roof Rack Bars (1) Battery (28) Coil (2) Air Vents (5) Bushings (2) Arm (1) Grille (1) Gearbox (2) Spark plugs (15) Glow plugs (3) Bodywork (8) Glove box (1) Control unit (8) Key (43) Locking the trunk (2) Timing belt (30) V-belt (5) Air conditioning (3) Air conditioning controls (4) -board computer (27) Checks and maintenance (146) Oil pan (1) Throttle body (1) Dashboard (15) Gearshift gaiter (1) Bearing (7) Brake discs (8) Rear bench seat (1) Side indicator light (2) Headlight (31) Tail light (11) Fog lights (8) Air filter (23) Cabin air filter (24) Petrol filter (10) Diesel filter (28) Oil filter (8) Hand brake (10) Clutch (7) Grille (6) Injectors (8) Window lift switch (2) Reverse gear switch (1) Accessory Kit (12) Light bulb (22) Side turn signal light bulb (9) Headlight bulb (37) Rear light bulb (26) Interior lights ceiling light bulb (12) Antifreeze liquid (3) Dashboard light (3) License plate light (4) Third brake light (3) Handle (18) Mask (1) Engine (17) Window motor (6) Starter motor (13) Engine oil (15) Power steering oil (2) Door panel (36) Windshield (1) Front bumper (17) Rear bumper (13) Brake pads (20) Hydraulic pistons (3) Tires (7) Gear Shift Knob (14) Pump (11) Fuel pump (30) Door (7) Push button (4) Window lift button (4) Instrument cluster (42) Radiator (9) Passenger compartment heating radiator (7) (1) Wheel (5) Fuse box (75) Seat (24) Drive shaft (2) Crankshaft RPM sensor (3) Coolant temperature sensor (1) Parking sensors (1) Lock (12) Lambda sensor (5) Suspensions (3) Outside rearview mirror (42) Interior rearview mirror (4) Engine mount (9) Drums and shoes (6) Windscreen wipers (19) Thermostat (10) Engine head (3) Transmission (1) Central tunnel (2) Turbine (7) Valve (3) EGR valve (5) Interior blower (18) Side window (6) Steering wheel (7)

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos