Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. GMC
    3. :
  3. Sierra
    4. : How to replace a GMC Sierra headlight bulb

GMC Sierra - Video tutorial

Model: GMC Sierra MK 4 - Years 2014-2018
Part: Headlight bulb
Operation: How to replace a GMC Sierra headlight bulb

It takes just a few minutes to replace the headlight bulb of your GMC Sierra (2015-2020) in complete autonomy. All you have to do is put into practice the various indications in the following mini guide. First switch off the vehicle completely and preferably also disconnect the battery so as to remove any possible passage of current. Immediately afterwards, lift the front bonnet and locate the protective cap in the internal part of the engine compartment (in correspondence with the headlight affected by the faulty bulb). Remove it and pull the connector slightly towards you. Disconnect the latter and proceed with the replacement of the bulb. Finally, reconnect the electrical pin and screw the protective cap back on.


Posted on 17 December 2022 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos