Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install a Multifunction Clock on the Great Wall Hover

Model: Great Wall Hover MK 0 - Years 2006-2012
Part: Clock

In this video, you will see how to install a multifunction clock on the Great Wall Hover, a component that is not standard on the vehicle. You can find the item indicated by the YouTuber on it. Aliexpress. Com with code 1005002766367352 at a price of £7.15 + £3.34 for delivery. You can choose the colour, and in addition to being a clock and date display, it measures internal and external temperature and battery voltage. The ideal position for installation is above the climate controls; you will need to take two measurements to centre it perfectly and then proceed with cutting (it won't be difficult to remove the trim using a plastic spatula), and since the profile is slightly higher, you will need to trim a little of the climate control edge; just a few millimetres will suffice. To prepare the connections, you will need a voltage tester to find the positive, attach the negative to the bodywork and the positive where you have identified it, securing it with tape. Install the connectors, and then there are the sensors; the short wire goes inside and the long one goes outside, passing from the lower part of the dashboard to the outside. Now, close everything up and test by running through all the various functions.

Updated on 18 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Timing Belt on a Great Wall Hover?
How to Replace the Timing Belt on a Great Wall Hover?
Great Wall Hover (2006-2012 / MK 0) To replace the timing belt on a Great Wall Hover, open the bonnet to access the components in the engine bay. Here, you will locate the air filter bo…
How do you replace the cabin filter of the Greatwall Hover?
How do you replace the cabin filter of the Greatwall Hover?
Great Wall Hover (2006-2012 / MK 0) To replace the cabin filter of the Greatwall Hover, you can loosen the screws that secure the glove box on the side of the front passenger so that it…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos