Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Evoque
    4. : How to change the oil in the automatic transmission of the Range Rover Evoque

Land Rover Evoque - Video tutorial

Model: Land Rover Evoque MK 1, L538 - Years 2011-2018
Part: Gear oil
Operation: How to change the oil in the automatic transmission of the Range Rover Evoque

Let's go through the steps required to replace the Range Rover Evoque transmission oil. First of all, we raise the car and begin to identify the gearbox oil vent bolt, which we find on the front transmission; then we use a hex wrench to unscrew it, letting the fluid drain into a container for about ten minutes, as shown in the video. At this point we reassemble the lower cover of the gearbox and remove the left front wheel to access the filler cap; unscrew the latter and connect a tube to be able to top up!


Posted on 28 September 2022 by ScegliAuto



To reset the service light on a Range Rover Evoque with automatic transmission.
Land Rover Evoque (2011-2018 / MK 1, L538) In this video, we can see how to reset the service light on a Range Rover Evoque with automatic transmission: it is important to note that the manual
How to unlock Range Rover Evoque automatic transmission
Land Rover Evoque (2018-2024 / MK 2, L551) The guide shows how to unlock Range Rover Evoque's automatic transmission in position N. If it is not possible to move the gearbox from position P to
How to replace the automatic transmission oil of the Land Rover Evoque
Land Rover Evoque (2011-2018 / MK 1, L538) Let's see how to change the automatic transmission oil of a Land Rover Evoque: (obviously, specific equipment is needed for this job and this is just

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos