Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Porsche
    3. :
  3. 911
    4. : Replacement discs and rear pads

Porsche 911 - Video tutorial

Model: Porsche 911 996 - Years 1997-2005
Part: Brake discs
Operation: Replacement discs and rear pads

To carry out this maintenance, lift the car on the bridge and remove the rear wheel; extract the safety split pin from the fixing pin of the spring applied behind the pads and remove the pin itself; remove the wear sensor from the pads and then the pads themselves; then proceed with disassembling the caliper complete with support and then unscrew the fixing screws of the disc on the hub with a percussion screwdriver; brush the disc seat on the hub, apply grease and install the new disc after cleaning it from the protective oil; reassemble the caliper, insert the new pads, the sensor, the spring and the pin without forgetting the split pin.


Posted on 9 September 2023 by ScegliAuto



Replacement of front brake discs and pads
Porsche 911 (1997-2005 / 996) Damaged brake discs can compromise braking so it is better to replace them. Remove the brake caliper using a ratchet wrench by unscrewing the two rea
Removal and replacement of brake discs
Porsche 911 (1997-2005 / 996) This video shows us how to remove and replace the brake discs of our car. First we lift the car with the help of a bridge and remove the rims to acce
Replacement brake discs and pads
Porsche 911 (1997-2005 / 996) Raise the car and remove the wheel. With a special tool and hammer, clean the head of the disc sealing screws, then remove them once they have been d

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos