Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : Engine mounts replacement instructions

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Engine
Operation: Engine mounts replacement instructions

The failure of the rubber supports of the engine is quite evident since at idle the engine tends to move particularly as well as to perceive noise especially in the starting and braking phases; replacing these supports is quite simple, just unscrew the lower fixing nut and then the upper one, lift the engine by applying a jack at the oil sump just enough to extract the old supports (driver and passenger side - we recommend the replacement of both -) and insert the new ones; then lower the motor and tighten the fixing nuts of the supports themselves.


Posted on 23 August 2023 by ScegliAuto

    Frequently Asked Questions

    • Serie 3 2012-2019 - What are the problems with the Bmw 318d 143hp engine? Read Answer
    • Serie 3 2012-2019 - What's the problem with the BMW 316d? Read Answer
    • Serie 3 2012-2019 - What problems can the BMW 316 d F31 have? Read Answer
    • Serie 3 2005-2013 - What are the problems with the 184 hp BMW 3 Series engine? Read Answer
    • Serie 3 2005-2013 - What problems afflict the N47 engine of the BMW 3 Series? Read Answer
    • Serie 3 2005-2013 - What does the yellow engine fault warning light on the BMW E90 mean? Read Answer
    • Serie 3 2005-2013 - How much does it cost to replace the intake manifold gaskets on the BMW 3 series? Read Answer
    • Serie 3 2005-2013 - How much hp does the BMW 3 series E90 have? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos