Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Santa Fe
    4. : How to replace oil and engine filter on Hyundai Santa Fe

Hyundai Santa Fe - Video tutorial

Model: Hyundai Santa Fe MK 2 - Years 2006-2012
Part: Engine oil
Operation: How to replace oil and engine filter on Hyundai Santa Fe

How to replace oil and engine filter on Hyundai Santa Fe? Let's see in this video guide how to proceed with the replacement. We lift the car with a column / jack bridge and unscrew the pin of the oil sump, let the oil flow into a container (we tighten the pin at the end of the drain). With a strap wrench we unscrew the container where the oil filter is located; we extract the same and place a new one, making it adhere well around the walls of the box. We bring the car back to the ground, then, we open the car door and pull up the engine compartment opening lever located at the bottom left of the dashboard and lift up the front hood, we secure the same. Finally we reassemble the oil filter cap, tighten the screws and top up with the new oil.


Posted on 3 November 2023 by ScegliAuto



How to change engine oil on Hyundai Santa Fe
Hyundai Santa Fe (2012-2018 / MK 3) How to change engine oil on Hyundai Santa Fe? Simple operation by following the right steps, let's see how to proceed: we lift the car on a column or
How to reset the oil light on the Hyundai Santa Fe.
Hyundai Santa Fe (2012-2018 / MK 3) Resetting the oil service light on a 2018 Hyundai Santa Fe, after replacing the filter and changing or topping up the oil, is a very simple operation
How to replace the air filter on Hyundai Santa Fe
Hyundai Santa Fe (2012-2018 / MK 3) To replace the air filter of the Hyundai Santa Fe we start by opening the engine hood, we release the tabs that hold the cover of the air filter box,

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos