|
Do it yourself
| |||
| ||||
How to Install a Xenon HID Kit
Model: Hyundai Sonata
- Years 2004-2014
This tutorial explains how to install a xenon headlight kit on a Hyundai Sonata. After opening the bonnet, the headlight kit to be installed, the wiring, and the necessary tools are shown. First, remove the halogen bulb located on the passenger side and disconnect its electrical connection. Repeat the same step for the driver’s side bulb. Driver's side headlight: to install the xenon headlight, use the plastic cover from the replaced headlight but drill a hole of the correct diameter to insert the new headlight and its wiring. Position the headlight correctly in its place and attend to the wiring connections: the yellow wires must face upwards, the black wire must connect at the top, and the blue wire at the bottom. The video specifies that for the installation of the passenger headlight, do not wire the two connectors (blue and black) to the fork. At this point, connect the kit wiring to the car battery, ensuring the polarity matches. Use a 10 mm ratchet spanner to connect the fork connectors to the battery terminals. Prepare and clean the areas where the control units will be placed. They will be fixed using double-sided plates, after which the lamp connectors can be connected to them.
Updated on 8 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Hyundai Sonata
(2004-2014 /
)
The installation procedure for an HID kit involves several key steps: open the vehicle's bonnet, remove the headlamp unit cover, and extract the spar…
Hyundai Sonata
(2004-2014 /
)
To install the reverse camera kit, start by removing the dashboard where the monitor will be positioned. Retrieve the power cables and, following the…
Hyundai Sonata
(1998-2005 /
EF)
Lift the vehicle on a hydraulic ramp, remove the front right wheel (passenger side), and take off the wheel arch cover to access the pulleys. Loosen …
Other guides you may be interested in
|
How to Open a Stuck Boot on the Peugeot 407?
On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.109
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |