Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Discovery
    4. : Tail light

Land Rover Discovery - Tail light

Land Rover Discovery (2004-2010 / MK 3, L319, LR3, Discovery3)
How to replace the rear taillight of a Land Rover Discovery III
In this video we see how to change the rear light of a Land Rover Discovery III; we start by removing the two screws on the inside compared to the trunk …read all…
Posted on 6 April 2024 by ScegliAuto
Airbags (1) Alternator (2) Loudspeaker (1) Air conditioning (1) Car stereo (6) Battery (7) Gearbox (4) Glow plugs (1) Carburetor (1) Bodywork (1) Glove box (1) Key (9) Timing belt (8) V-belt (1) -board computer (4) Checks and maintenance (23) Dashboard (2) Differential (2) Headlight (4) Tail light (1) Air filter (1) Cabin air filter (4) Diesel filter (5) Oil filter (3) Hand brake (2) Injectors (1) Accessory Kit (4) Light bulb (1) Side turn signal light bulb (1) Headlight bulb (3) Rear light bulb (1) Antifreeze liquid (2) Dashboard light (3) Gear oil (2) Engine oil (1) Door panel (5) Front bumper (3) Brake pads (1) Hydraulic pistons (1) Pump (2) Fuel pump (4) Door (2) Instrument cluster (9) Fuse box (3) Seat (3) Lock (1) Windscreen wipers (3) Thermostat (1) Transmission (1) Turbine (1) EGR valve (2) Interior blower (4) Steering wheel (6)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos