Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. Boxer
    4. : Battery

Peugeot Boxer - Battery

Peugeot Boxer (2006-2023 / MK 2)
How to replace the battery on the Peugeot Boxer
If we want to replace the battery in do-it-yourself mode on this vehicle model, we will find the instructions and information to follow on the video and in the …read all…
Posted on 29 May 2023 by ScegliAuto
Peugeot Boxer (2006-2023 / MK 2)
How to identify and replace the Peugeot Boxer battery
The guide shows how to locate and replace the Peugeot Boxer battery. The battery is located in a special compartment inside the passenger compartment, under …read all…
Posted on 13 February 2024 by ScegliAuto
Peugeot Boxer (2006-2023 / MK 2)
Battery replacement on Peugeot Boxer and Fiat Ducato
Remove the protective flap on which the driver rests his feet, then the one immediately before the pedals. Unscrew the bolts that secure the sheet and remove …read all…
Posted on 21 January 2024 by ScegliAuto
Shock absorbers (2) Car stereo (1) Battery (3) Glow plugs (1) Key (1) Timing belt (1) -board computer (5) Checks and maintenance (27) Headlight (1) Air filter (1) Cabin air filter (2) Diesel filter (1) Clutch (3) Grille (1) Light bulb (1) Side turn signal light bulb (1) Headlight bulb (5) Rear light bulb (1) License plate light (1) Window motor (1) Starter motor (2) Engine oil (1) Door panel (1) Rear bumper (1) Pump (1) Fuel pump (1) Instrument cluster (9) Radiator (1) Wheel (2) Fuse box (19) Suspensions (1) Outside rearview mirror (6) Windscreen wipers (1) Valve (1) EGR valve (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos