Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Clutch Replacement Instructions

Model: Peugeot 106 MK 1 - Years: 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002
Part: Clutch

Video tutorial

Replacing the clutch is not typically a DIY maintenance task, but if you have some tools and good mechanical knowledge, you can proceed. Lift the vehicle on a ramp or suitable axle stands, drain the oil from the gearbox, and in the meantime, remove the battery and the air filter housing to disconnect the clutch cable, gear cables, starter motor, and reverse switch connector.

Move on to disassembling the driveshaft by freeing the hub from the joint to slide the driveshaft out of the gearbox and continue by removing the gearbox from its support. Once the gearbox is removed, take off the release bearing, the clutch disc, and the thrust bearing.

Clean the flywheel, use the alignment tool to install the new disc and the corresponding pressure plate, apply the new bearing, and reinstall the gearbox along with everything previously removed, finally filling the gearbox with new oil.


Updated on 14 February 2026 by ScegliAuto


Related tutorials

Instructions for Replacing Engine Oil
Instructions for Replacing Engine Oil
Peugeot 106 (1991-2004 / MK 1) To replace the engine oil, place the vehicle on suitable car ramps, position a container of appropriate capacity under the oil sump, aligned with the…
Instructions for Replacing the Fuel Filter
Instructions for Replacing the Fuel Filter
Peugeot 106 (1991-2004 / MK 1) The fuel filter is located underneath the vehicle near the left rear wheel: raise the vehicle on suitable axle stands, unclip the retaining strap of …
Instructions for Replacing Injectors
Instructions for Replacing Injectors
Peugeot 106 (1991-2004 / MK 1) Injectors serve to inject fuel into the combustion chamber, atomising it at high pressure to mix well with the air and create the perfect thermodynam…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos