Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to replace the battery on Volkswagen Polo

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo 4, MK 4, Polo IV, 9N, MK IV - Years 2001-2009
Part: Battery
Operation: How to replace the battery on Volkswagen Polo

How to carry out maintenance on Volkswagen Polo? This video explains how to replace the battery in the engine compartment: open the car door and pull up the engine compartment opening lever located at the bottom left of the dashboard and lift up the front hood, releasing the lever with your fingers. block of the same, then, we put in safety. Once the engine compartment is open, we will find the battery on the right; disassemble the locking pins of the battery terminals (after removing the plastic cover), then, remove it from the engine compartment and replace it with a new one (same voltage). We close the bonnet at the end of the maintenance.


Posted on 31 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Polo 2001-2009 - How many amps is the battery of the Volkswagen Polo? Read Answer
    • Polo 2009-2017 - How many amps must the battery of a Polo 1.4 diesel with positive pole on the left be? Read Answer
    • Polo 2009-2017 - How many Ah must be the battery for the VW Polo1.2 petrol? Read Answer
    • Polo 2001-2009 - How many amps should the battery have for the VW Polo 1.4 petrol? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos