Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volvo
    3. :
  3. V60
    4. : How to replace the Volvo V60 diesel filter

Volvo V60 - Video tutorial

Model: Volvo V60 MK 2 - Years 2018-2024
Part: Diesel filter
Operation: How to replace the Volvo V60 diesel filter

The guide shows you how to replace the Volvo V60 diesel filter. The diesel filter, in this vehicle, is located in the rear right part; The vehicle must be raised to perform the replacement. Using a filter wrench, unscrew the housing cap, placing a container to catch the fuel. Drain all the fuel present in the filter and discard the exhausted cartridge. Clean the housing cap and replace the gasket. Fit the new filter cartridge and fill the filter cap with new diesel fuel. Tighten the filter to 25 Nm and clean the fuel residues. From the driver's seat, insert the key and long press the power button; you will hear the fuel pump operate. Turn off the ignition by pressing the power button again. Carry out this procedure 5/6 times; start the engine for a few minutes to allow the diesel fuel to circulate completely in the filter.


Posted on 17 March 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • V60 2018-2025 - Where is the fuel filter located on the Volvo V60? Read Answer
    • V60 2018-2025 - How to change the diesel filter in the Volvo V60? Read Answer
    • V60 2010-2018 - How to replace the diesel filter in the Volvo V60? Read Answer
    • V60 2018-2025 - When should the diesel filter on a Volvo V60 be replaced? Read Answer
    • V60 2010-2018 - Where is the diesel filter located on Volvo V60? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos