Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Freelander
    4. : Hydraulic pistons

Land Rover Freelander - Hydraulic pistons

Land Rover Freelander (2006-2016 / Freelander2)
Replacing the clutch pistons on a Land Rover Freelander
First of all we need to remove the battery pack and the entire intake filter box to access the component to be replaced. Unscrew the pin that hinges the pump …read all…
Posted on 6 December 2023 by ScegliAuto
Airbags (1) Car stereo (10) Battery (5) Air Vents (2) Arm (1) Gearbox (1) Spark plugs (2) Soft top (1) Bodywork (1) Key (7) Locking the trunk (1) Timing belt (13) V-belt (3) -board computer (4) Checks and maintenance (20) Dashboard (1) Bearing (1) Differential (4) Brake discs (1) Headlight (3) Tail light (2) Fog lights (1) Particulate filter (1) Air filter (7) Cabin air filter (7) Diesel filter (8) Oil filter (1) Clutch (4) Light bulb (1) Headlight bulb (5) Handle (2) Engine (1) Starter motor (1) Engine oil (2) Power steering oil (1) Door panel (7) Front bumper (1) Brake pads (1) Hydraulic pistons (1) Gear Shift Knob (7) Fuel pump (5) Door (2) Instrument cluster (6) Fuse box (4) Lock (4) Suspensions (1) Engine mount (1) Central tunnel (1) Turbine (1) EGR valve (2) Steering wheel (3)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos