Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Clutch replacement instructions

Model: Subaru Forester MK 2, SG - Years 2002-2008
Part: Clutch

Replacing the clutch requires good knowledge of general mechanics and some tools; then lift the car on the lift and start removing the front section of the exhaust pipe; then remove the left front wheel, the axle shaft fixing nut, the head of the suspension oscillating arm, that of the steering box tie rod in order to remove the axle shaft from the wheel hub; therefore extract the locking pin of the semi-shaft from the gearbox side and remove the semi-shaft itself; repeat the procedure also from the right side, remove the transmission shaft protective casings and disassemble the shaft itself. At this point, unscrew the gearbox fixing pins, disconnect the sockets, remove the starter motor and the air filter container to access the gearbox support below and the clutch actuator. Once the gearbox has been released, apply a support piston and remove it from its seat in order to access the clutch and replace the disc and pressure plate (clean the flywheel from dust residues) centering them with the appropriate tool; finally replace the thrust bearing inside the gearbox and reassemble everything.


Posted on 14 August 2023 by ScegliAuto



Subaru Forester battery replacement
Subaru Forester (2008-2011 / MK 3, SH) Today we will see the instructions that will allow us to remove and replace the battery of the Subaru Forester, in simple and quick steps. First of a
Where is the Subaru Forester fuse box
Subaru Forester (2008-2011 / MK 3, SH) Finding the fuse box inside your Subaru Forester is not very difficult, but if you are having difficulty, just follow the instructions in this mini g
Subaru Forester 2.5L timing belt replacement guide
Subaru Forester (2008-2011 / MK 3, SH) This short video will show us the main instructions that will allow us to remove and replace the timing belt and the water pump of the Subaru Foreste

Other guides that may interest you

How to remove the telepass holder from the windshield

Today we will explain how to remove the telepass holder from a vehicle's windshield. Removing the telepass holder from the windshield is a very simple and quick operation to perform independently, you just need to use nylon thread that you will need to pull towards the holder and pass it between the holder and the clip. After performing this operation, the holder will be removed. There may be glue residues on the windshield that can be removed with a solvent suitable for glass cleaning. After cleaning everything, it is possible to mount another telepass holder on the windshield in the same position as the one removed or elsewhere.

Watch the video!


by ScegliAuto

More videos