Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Citroen Xsara Picasso - Door

Citroen Xsara Picasso (1999-2012 / MK 1)
Remove the inside of the door of the Citroen Xsara
To start, remove the handle frame and with the help of a screwdriver remove the armrest, removing the two screws underneath. Then you can unscrew the screw …read all…
Posted on 3 May 2024 by ScegliAuto
Airbags (2) Loudspeaker (1) Shock absorbers (1) Car stereo (5) Roof Rack Bars (1) Battery (18) Air Vents (1) Gearbox (2) Spark plugs (1) Bodywork (1) Control unit (3) Key (5) Timing belt (4) V-belt (2) -board computer (1) Checks and maintenance (12) Dashboard (2) Brake discs (2) Headlight (2) Tail light (5) Air filter (3) Cabin air filter (4) Petrol filter (1) Diesel filter (4) Clutch (5) Light bulb (1) Headlight bulb (7) Rear light bulb (3) Interior lights ceiling light bulb (2) Dashboard light (7) License plate light (1) Third brake light (1) Window motor (1) Starter motor (1) Door panel (7) Rear bumper (1) Brake pads (1) Gear Shift Knob (6) Fuel pump (5) Door (1) Instrument cluster (4) Radiator (1) Passenger compartment heating radiator (3) Cockpit heating cock (2) Wheel (1) Fuse box (9) Seat (5) Coolant temperature sensor (2) Suspensions (1) Outside rearview mirror (4) Windscreen wipers (2) Thermostat (1) Interior blower (4) Steering wheel (3)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos