Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to replace the clutch master cylinder in the Ford Focus?

Ford Focus - Video tutorial

Model: Ford Focus MK 1 - Years 1998-2004
Part: Pump
Operation: How to replace the clutch master cylinder in the Ford Focus?

In this video we can see how to replace the clutch pump in the Ford Focus. For this operation we need: 8,10,11 and 13mm socket wrenches, 11 and 10mm wrenches, various screwdrivers and Super Dot 4 brake fluid. air. Next, we remove the glove box located above the pedal set, the air conditioning ducts, the various pedal switches and disconnect the steering column. We continue by unscrewing the pump fixing bolts, disconnecting the two liquid pipes and unscrewing the further bolt. At this point we can replace the pump, reassemble everything following the reverse procedure and top up with liquid, taking care to let all the air out of the circuit.


Posted on 4 April 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Focus 2011-2018 - What problems could the Ford Focus injector pump have? Read Answer
    • Focus 2004-2011 - How much is the water pump on the Ford Focus 1.8 TDCi from 2005? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos