Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Engine Air Filter with K&N Model

Model: Porsche 911 996 - Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: Accessory kit

See other generations:
Video tutorial

Disconnect the connector attached to the mass air flow sensor, loosen the clamp on the hose connected to the throttle body, and unscrew the screws securing the engine air filter housing and remove it. First, apply a gasket along the edge of the support bracket for the new filter, provided with the installation kit, place it in the seat of the old filter, and mark the points where to drill holes to secure it to the vehicle's frame.

Once the bracket is secured, attach the silicone hose to the edge of the throttle body, securing it with a metal clamp, and connect the new intake duct to the hose (the mass air flow sensor will already be attached to the duct to which the original connector will be connected).

Finally, install the intake cone.


Updated on 4 February 2026 by ScegliAuto


Related tutorials

Cabin Air Filter Replacement for Porsche 996
Cabin Air Filter Replacement for Porsche 996
Porsche 911 (1997-2005 / 996) Both the engine air filter and the cabin air filter replacement are maintenance tasks that you can easily perform yourself, despite the vehicle's imp…
Replace the Air Filter on the Porsche 997
Replace the Air Filter on the Porsche 997
Porsche 911 (2005-2011 / 997) Changing the air filter on the Porsche 997 is a task performed approximately every 12,400 miles and greatly helps the proper functioning of the engin…
Installing Engine Air Filter from Competition
Installing Engine Air Filter from Competition
Porsche 911 (1997-2005 / 996) Open the rear hood and ensure it is securely supported. Then, remove the original engine air filter housing by disconnecting the connector from the m…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos