Do it yourself
Frequently asked questions about cars and motorcycles

How to perform a DIY service on a Peugeot 308 1st series 1.6 HDi 109 HP Diesel 9HY (DV6TED4)

Model: Peugeot 308 T7, MK 1 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Part: Engine oil

See other generations:
Video tutorial

Doing a DIY service on your Peugeot 308 1.6 HDi is feasible with a bit of patience and the right tools. First thing: car on flat ground, hood open.

Drain the old oil by unscrewing the plug under the oil pan (be careful not to burn yourself), change the oil filter by unscrewing it with a strap wrench and install a new one, well-oiled on the gasket. Top up with about 3.8L of 5W30 oil and close everything.

Then, air filter: open the box, replace it, and close it. Finally, fuel filter: disconnect the pipes calmly, change the filter, reassemble and bleed by pumping fuel with the pump. Check the levels again, start the engine and make sure everything is okay.

Reset the service light and you're good to go! If you don't feel comfortable doing it yourself, and it's understandable, make an appointment at an experienced workshop.


Posted on 30 September 2025 by ScegliAuto


Related tutorials

Peugeot 308 (2007-2014 / T7, MK 1) The following steps will show you how to remove and replace the alternator on a Peugeot 308 1.6 HDI. First, open the bonnet of the vehicle and discon…
Peugeot 308 (2013-2021 / T9, MK 2) Today, let's go through the steps necessary to remove and replace the timing belt and water pump on the Peugeot 308 1.6 HDI. First, raise the vehicle…
Peugeot 308 (2007-2014 / T7, MK 1) In this guide, you will learn how to reset the oil change light for the Peugeot 308. The model examined in the video features a turbo-diesel HDi engi…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos