Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Elantra
    4. : Lambda sensor

Hyundai Elantra - Lambda sensor

Hyundai Elantra (2000-2006 / MK 3, XD)
Replacement of the lambda sensor of the Hyundai Elantra
Today, we will see the instructions that will allow us to disassemble and replace the lambda probe of the Hyundai Elantra; the fault is manifested by the …read all…
Posted on 1 October 2023 by ScegliAuto
Hyundai Elantra (2006-2010 / MK 4, HD)
How to replace the Lambda probe of a Hyundai Elantra
Let's see in this video how to replace the Lambda probe of a Hyundai Elantra. We pull the lever to open the engine compartment located at the bottom left of …read all…
Posted on 30 September 2023 by ScegliAuto
Alternator (1) Loudspeaker (1) Shock absorbers (4) Car stereo (7) Battery (7) Coil (3) Bushings (1) Arm (6) Gearbox (1) Spark plugs (4) Glove box (1) Key (6) Timing belt (9) -board computer (4) Checks and maintenance (14) Oil pan (1) Dashboard (1) Bearing (1) Brake discs (3) Headlight (4) Tail light (3) Fog lights (1) Air filter (8) Cabin air filter (7) Petrol filter (1) Oil filter (1) Clutch (1) Accessory Kit (4) Light bulb (1) Side turn signal light bulb (1) Headlight bulb (5) Rear light bulb (4) Interior lights ceiling light bulb (1) License plate light (1) Third brake light (4) Handle (9) Engine (6) Window motor (1) Starter motor (2) Gear oil (1) Door panel (1) Front bumper (2) Brake pads (3) Tires (1) Pump (2) Fuel pump (3) Door (1) Instrument cluster (3) Radiator (1) Passenger compartment heating radiator (1) Fuse box (6) Seat (1) Drive shaft (1) Lambda sensor (2) Suspensions (1) Outside rearview mirror (4) Drums and shoes (1) Engine head (2) Valve (1) Interior blower (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos