Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Peugeot
  4. :
  5. Partner Tepee
  6. : Headlight bulb

Peugeot Partner Tepee - Headlight bulb

Peugeot Partner Tepee (2008-2018 / B9)
Replace the headlight bulb of the Peugeot Partner 2019.

If the position light bulb of our Peugeot Partner were to burn out, we must replace it as soon as possible. To change it, we need to open the engine hood and …read all…
Posted on 20 September 2023 by ScegliAuto
Peugeot Partner Tepee (2008-2018 / B9)
Replacing the front bulbs on Peugeot Partner

When working with the engine off and the handbrake on, lift the hood and place the appropriate support rod. The video shows you the replacement of each …read all…
Posted on 23 February 2024 by ScegliAuto

Alternator (1) Car stereo (4) Battery (6) Glow plugs (1) Key (4) Timing belt (7) -board computer (2) Checks and maintenance (37) Dashboard (1) Tail light (1) Particulate filter (2) Air filter (4) Cabin air filter (4) Diesel filter (5) Clutch (1) Light bulb (4) Headlight bulb (2) Rear light bulb (5) License plate light (3) Engine (6) Starter motor (1) Gear oil (2) Engine oil (3) Door panel (7) Brake pads (2) Hydraulic pistons (1) Tires (4) Gear Shift Knob (2) Pump (1) Push button (1) Instrument cluster (11) Radiator (1) Fuse box (13) Seat (2) Coolant temperature sensor (1) Outside rearview mirror (1) Engine mount (1) Thermostat (2) Turbine (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos