Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe M
    4. : Antifreeze liquid

Mercedes Classe M - Antifreeze liquid

Mercedes Classe M (1997-2005 / W163)
Replacement radiator fluid reservoir
If it is necessary to replace the coolant reservoir, it is recommended to proceed only after the engine has cooled completely; at this point, start by draining …read all…
Posted on 30 August 2023 by ScegliAuto
Mercedes Classe M (1997-2005 / W163)
Instructions for replacing antifreeze liquid
To be sure that the coolant is always efficient, it is advisable to replace it, perhaps during regular maintenance: in this way you will avoid the formation of …read all…
Posted on 29 August 2023 by ScegliAuto
Mercedes Classe M (1997-2005 / W163)
Coolant drain instructions
If the engine cooling system needs to be drained, it is recommended that you first carry out this operation with the engine cold to avoid unpleasant burns; the …read all…
Posted on 26 August 2023 by ScegliAuto
Mercedes Classe M (1997-2005 / W163)
Coolant replacement
The guide below shows us how to replace the radiator coolant. When the engine is cold, the coolant level must be between the maximum and the minimum. To avoid …read all…
Posted on 28 July 2023 by ScegliAuto
Mercedes Classe M (1997-2005 / W163)
Check for coolant leaks
If the coolant level warning light comes on on the instrument panel display, check the level in the relevant reservoir. Once the front hood is open, the …read all…
Posted on 27 July 2023 by ScegliAuto
Airbags (3) Loudspeaker (2) Air conditioning (3) Car stereo (5) Battery (11) Coil (1) Air Vents (3) Gearbox (8) Spark plugs (1) Glow plugs (4) Bodywork (4) Control unit (1) Key (5) Timing belt (1) V-belt (4) Air conditioning controls (1) -board computer (7) Checks and maintenance (25) Dashboard (1) Bearing (2) Mass air flow sensor (1) Brake discs (1) Headlight (5) Tail light (3) Fog lights (1) Air filter (8) Cabin air filter (6) Oil filter (1) Hand brake (1) Clutch (1) Grille (2) Accessory Kit (4) Light bulb (1) Side turn signal light bulb (2) Headlight bulb (4) Rear light bulb (2) Antifreeze liquid (5) License plate light (1) Third brake light (1) Engine (8) Gear oil (1) Engine oil (4) Door panel (5) Front bumper (4) Rear bumper (6) Brake pads (3) Hydraulic pistons (1) Tires (3) Pump (1) Fuel pump (6) Door (3) Push button (2) Window lift button (5) Instrument cluster (4) Radiator (4) Fuse box (17) Crankshaft RPM sensor (1) Lock (2) Suspensions (1) Outside rearview mirror (2) Transmission (1) Central tunnel (4) EGR valve (1) Interior blower (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos