Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe M
    4. : Glow plugs

Mercedes Classe M - Glow plugs

Mercedes Classe M (1997-2005 / W163)
How to replace glow plugs in Mercedes ML?
In this tutorial we can see how to replace the glow plugs in the Mercedes ML, a simple operation that requires manual skills. Let's start by opening the engine …read all…
Posted on 29 November 2022 by ScegliAuto
Mercedes Classe M (1997-2005 / W163)
How to replace the glow plugs in the Mercedes M-Class?
Replacing the glow plugs in the Mercedes M-Class is very simple, let's see how to proceed in this tutorial. First, we clean the top of the engine thoroughly …read all…
Posted on 14 September 2022 by ScegliAuto
Mercedes Classe M (2005-2011 / W164)
Mercedes ML glow plug replacement
Let's find out in this guide how to disassemble and replace the glow plugs of the Mercedes ML engine, with V6 engine, following the instructions below. First …read all…
Posted on 18 April 2024 by ScegliAuto
Mercedes Classe M (2005-2011 / W164)
Replacement glow plugs on Mercedes Ml
Are the Mercedes ML glow plugs damaged? Let's see how the M is removed from above. We pull the engine compartment opening lever located at the bottom left of …read all…
Posted on 9 December 2023 by ScegliAuto
Airbags (3) Loudspeaker (2) Air conditioning (3) Car stereo (5) Battery (11) Coil (1) Air Vents (3) Gearbox (8) Spark plugs (1) Glow plugs (4) Bodywork (4) Control unit (1) Key (5) Timing belt (1) V-belt (4) Air conditioning controls (1) -board computer (7) Checks and maintenance (25) Dashboard (1) Bearing (2) Mass air flow sensor (1) Brake discs (1) Headlight (5) Tail light (3) Fog lights (1) Air filter (8) Cabin air filter (6) Oil filter (1) Hand brake (1) Clutch (1) Grille (2) Accessory Kit (4) Light bulb (1) Side turn signal light bulb (2) Headlight bulb (4) Rear light bulb (2) Antifreeze liquid (5) License plate light (1) Third brake light (1) Engine (8) Gear oil (1) Engine oil (4) Door panel (5) Front bumper (4) Rear bumper (6) Brake pads (3) Hydraulic pistons (1) Tires (3) Pump (1) Fuel pump (6) Door (3) Push button (2) Window lift button (5) Instrument cluster (4) Radiator (4) Fuse box (17) Crankshaft RPM sensor (1) Lock (2) Suspensions (1) Outside rearview mirror (2) Transmission (1) Central tunnel (4) EGR valve (1) Interior blower (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos